Allied Telesis AT-S60 - Manual (Page 90)

Chapter 6: Enhanced Stacking Commands
88
ACCESS SWITCH
Syntax
access switch number=number|macaddress=macaddress
Parameters
number Specifies the number of the switch in an enhanced
stack that you want to manage. Display this number
using the SHOW REMOTELIST command.
macaddress Specifies the MAC address of the switch you want to
manage. This value can also be displayed using the
SHOW REMOTELIST command. You can enter the
address in either of the following formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
Description
This command starts a management session on another switch that
supports enhanced stacking, such as another AT-8400 Series switch or
an AT-8000 Series switch. You can specify the switch by switch number
or by MAC address, both of which are displayed with SHOW
REMOTELIST on page 92.
Note
You must perform the ACCESS SWITCH command from a
management session of a master switch. This command will not
work from a management session of a slave switch. To determine
the master or slave status of your switch, use SHOW SWITCH on
page 55.
Note
You must perform the SHOW REMOTELIST command before using
the ACCESS SWITCH command.
When you are finished managing a slave switch, use the EXIT command
to end the management session and return to the master switch from
which you started the management session. For information, refer to
EXIT on page 90.