Allied Telesis AT-S60 - Manual (Page 173)

AT-S60 Command Line User’s Guide
171
SET MSTP
Syntax
set mstp [default]
[forceversion=forcestpcompatible|normalmstp]
[hellotime=hellotime] [forwarddelay=forwarddelay]
[maxage=maxage] [maxhops=maxhops]
[configname=”name”] [revisionlevel=number]
Parameters
default Disables MSTP and returns all bridge and port MSTP
settings to the default values. This parameter cannot
be used with any other parameter. (This parameter
performs the same function as the RESET MSTP
command.) The spanning tree protocol must be
disabled to use this parameter.
forceversion Controls whether the bridge will operate with
MSTP or in an STP-compatible mode. If you select
MSTP, the bridge will operate all ports in MSTP,
except for those ports that receive STP or RSTP
BPDU packets. If you select Force STP Compatible,
the bridge uses its MSTP parameter settings, but
sends only STP BPDU packets from the ports
The options are:
forcestpcompatible The bridge uses the MSTP
parameter settings, but
transmits only STP BPDU
packets from the ports.
normalmspt The bridge uses MSTP. The
bridge sends out MSTP BPDU
packets from all ports except
for those ports connected to
bridges running STP. This is
the default setting.
hellotime Specifies the time interval between generating and
sending configuration messages by the bridge. This
parameter can be from 1 to 10 seconds. The default is
2 seconds.