Allied Telesis AT-S60 - Manual (Page 97)

AT-S60 Command Line User’s Guide
95
SET SWITCH PORT
Syntax
set switch port=port [status=enabled|disabled]
[flowcontrol=disable|enable|auto]
[holblocking=enabled|disabled]
[broadcastfilter=enabled|disabled]
[backpressure=enabled|disabled]
[mdimode=mdi|mdix|auto]
[speed=autonegotiate|10mhalf|10mfull|10mhauto|
10mfauto|100mhalf|100mfull|100mhauto|100mfauto|
1000mfull|1000mfauto]
[priority=nooverride|lowpriority|highpriority]
Parameters
port Specifies the port you want to configure. You can
specify more than one port at a time. (For
information on how to enter ports, refer to
Specifying Ports on page 17.)
status Specifies the operating status of the port. Possible
settings are:
enabled The port will forward Ethernet frames.
This is the default setting.
disabled The port will not forward frames.
flowcontrol Specifies the flow control on the port. Possible
values for this parameter are:
disabled No flow control.
enabled Flow control is activated.
auto The switch sets flow control to match
flow control on the end node
connected to the port. If the end node
is using flow control, the switch port
also uses flow control. If the end node
is not using flow control, neither will
the switch port.
holblocking Enables and disables head-of-line blocking on the
port. Options are:
enabled Enables head-of-line blocking.
disabled Disables head-of-line blocking.