Allied Telesis AT-S60 - Manual (Page 207)

AT-S60 Command Line User’s Guide
205
SET GARP PORT
Syntax
set garp=gvrp port=port|ALL [mode=normal|none]
Parameters
garp Specifies the GARP application you want to
configure. The only GARP application supported by
AT-S60 management software is GVRP.
port Specifies the port (that is, slot.port) you want to
configure on the switch. You can specify more than
one port at a time. (For information on how to enter
ports, refer to Specifying Ports on page 17.) To
specify all ports on the switch, use ALL.
mode Specifies the GVRP mode of the port. Modes are:
normal The port will participate in GVRP. The
port will process GVRP information and
transmit PDUs. This is the default.
none The port will not participate in GVRP.
The port will not process GVRP
information nor transmit PDUs.
Note
The online help for this command contains an STP option. The
option is not supported.
Description
This command sets a port’s GVRP status. If you want a port to learn
remote VLANs and transmit PDUs, set its mode to Normal. If you do not
want a port to participate in GVRP, set its mode to None.
Examples
The following command instructs ports 1 to 4 on the line card in slot 3 to
not participate in GVRP:
set garp=gvrp port=3.1-4 mode=none