Allied Telesis AT-S60 - Manual (Page 54)

Chapter 3: Basic Switch Commands
52
SHOW DHCPBOOTP
Syntax
show dhcpbootp
Parameters
None.
Description
This command displays the status of the DHCP and BOOTP client
software on the switch. The status is either “enabled” or “disabled.” The
default setting for DHCP and BOOTP is disabled.
To enable DHCP and BOOTP client software, refer to ENABLE
DHCPBOOTP on page 31. To disable the DHCP and BOOTP client
software, refer to DISABLE DHCPBOOTP on page 29.
Example
The following command displays the status of the DHCP and BOOTP
client software:
show dhcpbootp