Allied Telesis AT-S60 - Manual (Page 72)

Chapter 5: SNMP Community Strings and Trap Commands
70
ADD SNMP COMMUNITY
Syntax
add snmp community=community [traphost=ipaddress]
[manager=ipaddress]
Parameters
community Specifies an existing SNMP community string on the
switch.
traphost Specifies the IP address of a trap receiver.
manager Specifies the IP address of a management
workstation that has SNMP access to the switch
using the community string.
Description
This command adds a trap receiver or a management station to an
existing community string.
The TRAPHOST parameter specifies a trap receiver for the SNMP
community string. This is the IP address of a device to which traps
generated by the switch are sent. A community string can have up to
eight IP addresses of trap receivers, but only one IP address can be
added at a time with this command.
The MANAGER parameter specifies the management station that is
permitted SNMP management access to the switch using the
community string. A community string can have up to eight IP addresses
of management stations, but only one IP address can be added at a time
with this command.
To create a new community string, refer to CREATE SNMP COMMUNITY
on page 72. To view the current community strings, refer to SHOW
SNMP on page 85.
Examples
The following command permits access by a management station with
the IP address of 149.212.11.22 to the switch through the “private”
community string:
add snmp community=private manager=149.212.11.22