Allied Telesis AT-S60 - Manual (Page 88)

Chapter 5: SNMP Community Strings and Trap Commands
86
❑ Trap receiver IP addresses - The IP addresses of management
stations to receive traps from the switch. To add IP addresses, refer
to ADD SNMP COMMUNITY on page 70. To delete trap receiver
IP addresses, refer to DELETE SNMP COMMUNITY on page 75.
❑ Access Status - If a community string shows an Open Access with
Yes, the string has an open access status, meaning any
management workstations can use the string. A string with a
Open Access of No has a closed access status; only those
management workstations whose IP addresses have been
assigned to the string can use it. To change the access status, refer
to SET SNMP COMMUNITY on page 83.
Examples
The following command displays the SNMP status and the community
strings on the switch:
show snmp
The following command displays specific information about the
“private” community string. The information includes the IP addresses of
management workstations that can use the string and the IP addresses
of trap receivers:
show snmp community=private