Allied Telesis AT-WL2411 User Manual
Page 99
AT-WL2411 Version 1.80 Installation and User’s Guide
99
❑ In the Tunnel Filters screen, configure the filters in root candidates
and in other access points that can be attached through an IP
tunnel. IP tunnel filters are consistent with Ethernet filters.
❑ For networks using IP networking on end devices, it is
recommended that you enable the ARP server capability in the
access points.
❑ Determine if you need to enable bridging on remote subnets. For
example, bridging must be enabled if an NNL gateway is attached
to the remote subnet. For help, see
on page 78. The designated bridge candidates
must have permanent IP addresses and must be able to receive IP
hello messages from the root access point. An access point will
receive IP hello messages if the messages are sent to the unicast
IP address of the access point, or to an IP-directed broadcast or IP
multicast address. Note you may need to enable IGMP for IP
multicast.
To configure the IP Tunnels screen, perform the following procedure:
1. From the Main Menu, select IP Tunnels. The IP Tunnels screen as
shown in Figure 33 is displayed.
Figure 33 IP Tunnels Screen