Allied Telesis AT-WL2411 - Manual (Page 60)

Configuring the Ethernet Network
60
To configure the access point as a NAT server, perform the following
procedure:
1. From the Main Menu, select TCP/IP Settings. The TCP/IP Settings
screen as shown in Figure 16 is displayed.
Figure 20 TCP/IP Settings Screen
2. Verify that the IP Address field and IP Subnet Mask field are
configured. For help, see Configuring the TCP/IP Settings on page 52.
3. Select the down arrow on the right side of the DHCP Mode field and
choose This AP is a DHCP Server.
4. Select Submit Changes to save your changes.
5. Select DHCP Server Setup and enter a range of IP addresses that are
NOT on the same subnet as the access point.
6. Select Submit Changes to save your changes. To activate your
changes, Select Save/Discard Changes from the menu bar and then
Select Save Changes and Reboot. For help, see
Saving Your
Configuration Changes on page 46.