Allied Telesis AT-WL2411 - Manual (Page 188)

Advanced Configuration Commands
188
Using Access Point Monitor Commands
When you are in the access point monitor, the access point prompt
uap> appears. You can display a list of access point monitor commands
anytime you see the access point prompt.
To display access point monitor commands, press a letter or number key
on the keyboard, and then press Enter. A list of access point monitor
commands appears.
Note
If you type the letter B (upper or lower case) and press , the
access point will reboot. Type any letter or number other than B to
display access point commands.
The following example shows the list of available access point
commands. The commands are not case sensitive; you can type the
commands using either upper or lower case.
UAP Monitor V4.03 July 17,2000
uap>d
--------------------------------------------------------------------
----”uap>“ commands...
--------------------------------------------------------------------
----
B -Reboot | -Device IDs
menu
FX s -Ymodem File Download | MR -Display
Mfg Record
FD -File System Directory | TEST -Test Menu
FR -Run Flash Startup File | SRVC -Service Menu
-Manufacturing Menu | SR z -Serial Baud Rate
--------------------------------------------------------------------
----
uap>