Setting filter expressions – Allied Telesis AT-WL2411 User Manual
Page 74
Configuring the Ethernet Network
74
4. Select Submit Changes to save your changes. To activate your
changes, select Save/Discard Changes from the menu bar then
select Save Changes and Reboot. For help, see
Setting Filter
Expressions
You can set filter expressions by specifying parameters for packet filters.
You can also create a filter expression, which is executed in ascending
order based on the ExprSeq values until the access point determines
whether to pass or drop the frame.
To set filter expressions, perform the following procedure:
1. From the Main Menu, select Ethernet then Advanced Filters.
2. Select Filter Expressions. The Filter Expressions screen as shown in
Figure 27 Filter Expressions Screen
3. Configure the filter expressions parameters. The filter expressions
parameters are defined below.
ExprSeq (Expression Sequence)
Chains expressions together for filtering. After you change the
parameter, the statements are reordered and renumbered so the
Expression Sequence order is maintained. The range is from 0 to
255.