Allied Telesis AT-WL2411 - Manual (Page 106)

Configuring the Spanning Tree
106
Note
If you set the Scope field to Unlisted for any of the frame types, you
must also configure predefined subtype filters or customizable
subtype filters. For help, see
Using Predefined Subtype Filters on
page 106 or Customizing Subtype Filters on page 107.
5. Select Submit Changes to save your changes. To activate your
changes, select Save/Discard Changes from the menu bar then Save
Changes and Reboot. For help, see
Saving Your Configuration
Changes on page 46.
Using
Predefined
Subtype Filters
You can configure the access point to pass or drop certain predefined
frame subtypes.
To configure predefined subtype filters. perform the following
procedure:
1. From the Main Menu, select IP Tunnels then Tunnel Filters.
2. Select Predefined Subtype Filters. The Predefined Subtype Filters
screen as shown in Figure 37 is displayed.
Figure 37 Predefined Subtype Filters Screen
3. In each Allow/Pass field, check or uncheck the boxes to Allow or Pass.