Allied Telesis AT-WL2411 - Manual (Page 47)

AT-WL2411 Version 1.80 Installation and User’s Guide
47
Using a Telnet Session
To establish a Telnet configuration session, perform the following
procedure:
1. Go to an MS-DOS prompt and type Telnet IP address, where
IPaddress has the form x.x.x.x and x is a number from 0 to 255. Use the
IP address assigned to the AT-WL2411 you want to configure.
or
Open a Telnet program and type open. Press . At the
prompt, type the IP address of the AT-WL2411 and press
.
2. Follow the configuration instructions in Using a Serial Connection on
page 38, since the Telnet interface is similar to this communication
program interface.