Allied Telesis AT-WL2411 - Manual (Page 190)

Advanced Configuration Commands
190
SR Purpose
The SR command sets the baud rate of the access point.
Syntax
SR z
where z is the baud rate.
You must enter the baud rate as a whole number with no commas. For
example, to enter a baud rate of 19,200, you must enter 19200.
Setting Autobaud Using the SR Command
You can use autobaud to let the access point set its baud rate to match
the baud rate of your terminal, up to a baud rate of 115,200.
To set Autobaud using SR, perform the following procedure:
1. Set the baud rate to 0 using SR.
2. Press twice. The autobaud feature automatically detects the
baud rate of your terminal and sets the baud rate of the access point
to match.