Allied Telesis AT-WL2411 - Manual (Page 57)

AT-WL2411 Version 1.80 Installation and User’s Guide
57
5. Select DHCP Server Setup. The DHCP Server Setup screen as shown
in Figure 19 is displayed.
Figure 19 DHCP Server Setup
6. Configure the DHCP server using the following parameters:
Low Address
The low IP Address in the range of IP Addresses available to the
DHCP server for distribution to DHCP clients. If these addresses
are not on the same subnet as the access point, the access point
will perform Network Address Translation (NAT) for the devices to
which it grants IP Addresses.
High Address
the high IP address in the range of IP Addresses available to the
DHCP server for distribution to DHCP clients. If these addresses
are not on the same subnet as the access point, the access point
will perform Network NAT for the devices to which it grants IP
Addresses.
DNS Address 1
The IP Address of a Domain Name Server that will be distributed
to DHCP clients. You can enter up to two DNS addresses to be
delivered to DHCP clients.