Customizing subtype filters – Allied Telesis AT-WL2411 User Manual
Page 70
Configuring the Ethernet Network
70
3. Select Submit Changes to save your changes. To activate your
changes, select Save/Discard Changes from the menu bar and then
Save Changes and Reboot. For help, see
Customizing
Subtype Filters
You can configure the AT-WL2411 to pass or drop certain customized
frame subtypes. You define the action, subtype, and value parameters.
Action
Set the action to Pass or Drop. If you select Pass, then all frames of that
subtype and value are passed. If you select Drop, then all frames of that
subtype and value are dropped.
Subtype
Selects the frame subtype you wish to configure.
Value
The following table describes frame subtypes and their values. The value
must be two hex pairs. You must enter port values as decimals; for
example, enter 23. for port 23. The access point displays the
hexadecimal equivalent in the Value field on the menu. When a match is
found between frame subtype and value, the specified action is taken.
To customize subtype filters, perform the following procedure: