Allied Telesis AT-WL2411 - Manual (Page 146)

Configuring Security
146
Changing the
Default Login If you are not using a password server to authorize user logins, you
should change the default user name and password.
To set up logins, perform the following procedure:
1. From the Main Menu, select Security, then Passwords.The Password
screen as shown in Figure 56 is displayed.
2. Uncheck the Use RADIUS for Login Authorization box then Submit
Changes.
3. Configure the password parameters. The password parameters are
described below.
Use RADIUS for Login Authorization
Determines if you are using a password server to authenticate end
devices that can communicate with this access point. Clear this
check box.
User Name
Enter the user name you need to use to log in to this access point.
This parameter can be from 0 to 16 characters long.
If you leave the user name and password fields blank, a user will
not need to log in to the access point.
Password
Enter the password you need to use to log in to this access point.
This password gives you read and write access to the access point
configuration. This parameter can be from 0 to 16 characters long.
If you leave the user name and password fields blank, a user will
not need to log in to the access point.
Read Only Password
Enter the password you need to use to log in to this access point.
This password gives the user read-only access to the access point.
This user is able to view the configuration and execute diagnostics
but cannot perform any tasks that affect the operation of the
access point, such as changing configuration options, rebooting,
or downloading software.
To disable this password, delete it.