Allied Telesis AT-WL2411 - Manual (Page 48)

Configuration Overview
48
Using SNMP
The access point supports SNMP management. Contact your Allied
Telesyn representative for information about obtaining a copy of the
MIB. The passwords for accessing the SNMP community table are shown
below.
Type of Access MIB Password
read only public
read/write CR52401
Configuring the
SNMP
Community
Simple Network Management Protocol (SNMP) community strings are
passwords used by SNMP. When you use an SNMP client, you must enter
the correct community string to gain access to the access point SNMP
interface.
To configure the SNMP community, perform the following procedure:
1. Establish a Web browser session if you have not already done so. For
more information, see Using a Web Browser on page 43.
2. From the Main Menu, select Network Management. The Community
Strings screen as shown in Figure 15 is displayed.
Figure 15 Community Strings Screen