Allied Telesis AT-WL2411 - Manual (Page 192)

Advanced Configuration Commands
192
FFR Purpose
Runs a program that is specified by f, from a location specified by s.
Syntax
FFR f (s)
where:
f is the program name.
s is the optional segment location of the program.
Example: To run program access pointBOOT.PRG from segment 1, enter:
FFR access pointBOOT.PRG 1
PN Purpose
Returns the access point to normal mode from quiet mode.
Syntax
PN
To return the access point to normal mode, perform the following:
1. Reboot the access point.
2. The LEDs flash ON and OFF during the reboot. When the LEDs flash
OFF and only the Power LED remains ON, type !!! (three exclamation
points). The access point prompt (access point>) appears.
3. Type SRVC and press .
4. Type the service password (the default is EV98203S) and press
. The service prompt (service>) appears.
5. Type PN and press .
6. Type B to reboot the access point in normal mode.
PQ Purpose
Puts the access point in quiet mode. When the access point is in quiet
mode, you cannot access the access point monitor. You may want to use
quiet mode for security reasons.
Syntax
PQ