Allied Telesis AT-WL2411 - Manual (Page 52)

Configuring the Ethernet Network
52
Configuring the TCP/IP Settings
If you are using a DHCP server to automatically assign an IP address to
the access point, go to Configuring the Access Point as a DHCP Client in
the next section. If you are not using a DHCP server, you need to
manually assign some TCP/IP parameters.
You should have already configured an IP address for the access point,
as described in
Assigning an IP Address on page 41.
To configure the TCP/IP settings, perform the following procedure:
1. From the Main Menu, select TCP/IP Settings. The TCP/IP Settings
screen as shown in Figure 16 is displayed..
Figure 16 TCP/IP Settings Screen
2. Configure the TCP/IP settings using the following parameters:
IP Address
Enter the IP Address of the AT-WL2411. The IP Address has the
form x.x.x.x where x is a number from 0 to 225.