Allied Telesis AT-WL2411 - Manual (Page 33)

AT-WL2411 Version 1.80 Installation and User’s Guide
33
Attaching an External Antenna (Optional)
To attach an external antenna, you must disconnect the built-in antenna
and attach an antenna cable directly to the radio card in the access
point. For more information about antenna options, contact your local
Allied Telesyn representative.
To attach an antenna cable to the AT-WL2411, perform the following
procedure:
1. Remove the Radio Card Door. Refer to Figure 9.
2. Using pliers, gently pull the antenna wire to disconnect it from the
radio card, as shown in Figure 9.
Figure 9 Antenna Wire
3. Tuck the antenna wire inside the access point housing.
4. Remove the punch-out tab from the door, as shown in Figure 10.
Figure 10 Punch-out Tab
Door
Antenna
wire
Punch-out
tab
Pliers
Door