Allied Telesis AT-WL2411 User Manual
Page 100
Configuring the Spanning Tree
100
2. Select the down arrow on the right side of the Mode field and choose
Originate if Root to let the access point originate the tunnel if it is
functioning as the root access point for the network.
a. Choose Disabled if you do not want this access point to
participate in IP tunnels.
b. Chose Listen to configure access points that are designated
bridges or designated bridge candidates for their remote IP
subnet to serve as the endpoint of an IP tunnel.
3. Check or uncheck the box on the right side of the Enable IGMP to
Enabled or Disabled this feature.
Note
If you enable IGMP on the root access point, you need to enter the
Class D IP multicast address in the IP address list. For help, refer to
4. Select Submit Changes.
5. In the Multicast Address field, enter the multicast address. Unless
you have your own IP multicast address, the Internet Assigned
Numbers Authority has allocated 224.0.1.65 for the inter-access-point
protocol (IAPP). You should use this default multicast address.
6. Select Submit Changes to save your changes. To activate your
changes, select Save/Discard Changes from the menu bar then Save
Changes and Reboot. For help, see