Allied Telesis AT-WL2411 - Manual (Page 168)

Access Point Maintenance
168
11. Transfer the data files to the inactive data segment.
a. At the service> prompt, type fx s (where s is the inactive data
segment) and press . A series of Cs appears in the
command line.
b. Select the Transfer Menu tab in your communications
program and then Send File. The Send File dialog box appears.
c. Browse to the location where the data files are saved. Double-
click any data file. This file name appears in the Filename field.
d. To transfer all the data files at once, replace the specific file
name with an asterisk (*). For example, if the file name is
c:\2411uap\data\applets.dnl, change it to
c:\2411uap\data\*.dnl.
e. Select Send to start the file transfer. A P appears in the
command line when the transfer is complete.
12. Activate the inactive startup segment by typing fb s (where s is the
inactive startup segment) at the service> prompt and pressing
. A P appears in the command line when the operation is
complete.
13. Activate the inactive data segment by typing fb s (where s is the
inactive data segment) at the service> prompt and pressing
. A P appears in the command line when the operation is
complete.
14. Repeat Step 10 through Step 13 for the second startup file,
uapboot.dnl.
15. Type x at the service> prompt and press to return to the
ap> prompt.
16. To reboot the wireless access point, type b and press .
17. Reconfigure the wireless access point, if necessary, and save the
configuration. To activate the configuration, reboot the wireless
access point.