Allied Telesis AT-WL2411 - Manual (Page 196)

Advanced Configuration Commands
196
Using Console Commands
This section describes the console commands.
fb Purpose
Use the fb command to make an inactive segment the active segment.
Syntax
fb boot segment data segment
where:
boot segment is the name or number of the boot segment to be
activated.
data segment is the name or number of the data segment to be
activated.
Example
To make segment 2 the active boot segment and segment 4 the active
data segment, enter:
fb 2 4
You can use an asterisk instead of a segment name if you want to leave
that segment unchanged. For example, to leave the active boot
segment unchanged and make segment 4 the active data segment, you
could enter:
fb * 4
After loading software into the access point a common task is to activate
the new software. To activate the new software, enter:
Fb ib: id:
This command activates the inactive boot and data segments. You do
not need to know which of the boot and data segment numbers the
flash is loaded into.