Allied Telesis AT-WL2411 User Manual
Page 152
Configuring Security
152
4. Configure the RADIUS server parameters. The RADIUS parameters are
described below:
ACL Client Authorization
Determines if this access point uses an ACL. Click the down arrow
on the right side of the field and choose which radio uses an ACL
to authenticate end devices.
RADIUS Server #1 IP Address
Enter the IP address of the RADIUS server that contains the ACL.
If you are configuring an access point as a RADIUS server, enter
the IP address of the access point.
RADIUS Server #1 Secret Key
Enter the shared secret key for the RADIUS server. You can enter
the key from 1 to 32 characters in ASCII or in hexadecimal. To enter
a hexadecimal key, it must start with 0x. For example, enter the
ASCII key as ABCDE; enter the same hexadecimal key as
0x4142434445.
RADIUS Server #2 IP Address
Enter the IP address of the backup RADIUS server that contains
the ACL if RADIUS server #1 is unavailable.
You cannot use this server to provide more ACL entries.
RADIUS Server #2 Secret Key
Enter the shared secret key for the backup RADIUS server. You can
enter the key from 1 to 32 characters in ASCII or in hexadecimal.
To enter a hexadecimal key, it must start with 0x. For example,
enter the ASCII key as ABCDE; enter the same hexadecimal key as
0x4142434445.
5. Select Submit Changes to save your changes. To activate your
changes, select Save/Discard Changes from the menu bar then Save
Changes and Reboot. For help, see