Allied Telesis AT-WL2411 User Manual

Page 117

AT-WL2411 Version 1.80 Installation and User’s Guide

117

You may also need to adjust the flooding parameters. Follow these
recommendations when configuring the flooding parameters for a
point-to-point bridge:

❑ If there are no wireless end devices on the secondary LAN, the

access point on the secondary LAN can use the default flooding
settings.

To configure the master (in the point-to-point bridge on the primary
LAN), perform the following procedure:

From the Main Menu, select the link corresponding to the radio that
you are configuring.

Select Wireless Bridging. The Wireless Bridging screen as shown in
Figure 43 is displayed.

Figure 43 Wireless Bridging Screen

Select the down arrow on the right side of the Node Type field and
choose Master then Submit Changes. Your changes are saved and
the Wireless Hops parameter appears.

Select the down arrow on the right side of the Wireless Hops field
and choose Enabled then Submit Changes. Your changes are saved
and the Hello Period parameter appears.