Allied Telesis AT-WL2411 - Manual (Page 222)

Translated Electrical Safety and Emission Information
222
Standards: This product meets the following safety standards.
Standards: This product meets the following safety standards.
$ 1 RFI Emission EN55022 Class B
$ 2 Immunity EN55024
$ 3 Electrical Safety EN60950 (TUV), UL1950 (UL/cUL)
Safety
$ 4 Power to the access point must be sourced only from the adapter.
Europe—EC
Use TÜV licensed AC adapter of 5 V DC, min 2.0 A.
Other Countries
Use a Safety Agency Approved AC adapter of 5 V DC, min 2.0 A.
U.S. Federal Communications Commission
Declaration Of Conformity
Manufacture Name: Allied Telesyn, Inc.
Manufacture Address: 960 Stewart Drive, Suite B
Sunnyvale, CA 94085 USA
Manufacture Telephone: 408-730-0950
Declares that the product: Access Point
Model Numbers: AT-WL2411
This product complies with FCC Part 15B, Class B Limits:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device must not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Radiated Energy
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device pursuant to Part 15 of FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with instructions, may cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on. The user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications not expressly approved by the manufacturer or
registrant of this equipment can void your authority to operate this equipment
under Federal Communications Commission rules.
Canadian Department of Communications
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement
sur le matériel brouilleur du Canada.