Allied Telesis AT-WL2411 - Manual (Page 206)

Advanced Configuration Commands
206
tftp put Purpose
Copies a file from a client to the server or to another access point.
Syntax
tftp put IP address foreign filename local filename
where:
IP address is the IP address of the server. You can use
an asterisk (*) here if you want to use the
value in the serveripaddress.
foreign filename is the name of the file as it will appear on
the server. The file name can contain
directory path information and must be in
the format required by the server operating
system.
local filename is the name of the file to be sent from the
access point.
Example
The following command takes file access point.PRG that is saved in the
active boot drive on the access point client and stores it in the inactive
boot segment on the access point server that has IP address 1.2.3.4.
tftp put 1.2.3.4 ib:access point.prg ab:access
point.prg
The following error messages may be generated by the access point
when the access point issues a TFTP put command. Other error
messages may be returned from the server and displayed by the access
point. See your server documentation.
Error Message Explanation
Can’t read file The requested file may not exist.
Invalid opcode during put This error should not occur under normal
operating conditions. This error indicates a
TFTP protocol error that will not occur
when you use TFTP servers that conform to
the protocol.