Allied Telesis AT-WL2411 - Manual (Page 105)

AT-WL2411 Version 1.80 Installation and User’s Guide
105
The various frame type filters are explained below:
DIX IP TCP Ports
DIX IP UDP Ports
SNAP IP TCP Ports
SNAP IP UDP Ports
Primary Internet Protocol Suite (IP) transport protocols.
DIX IP Other Protocols
SNAP IP Other Protocols
IP protocols other than TCP or User Datagram Protocol (UDP).
DIX IPX Sockets
Novell NetWare protocol over Ethernet II frames.
SNAP IPX Sockets
Novell NetWare protocol over 802.2 SNAP frames.
802.3 IPX Sockets
Novell NetWare protocol over 802.3 RAW frames.
DIX Other Ethernet Types
SNAP Other Ethernet Types
DIX or SNAP registered protocols other than IP or IPX.
802.2 IPX Sockets
Novell running over 802.2 Logical Link Control (LLC).
802.2 Other SAPs
802.2 SAPs other than IPX or SNAP.
Note
You cannot filter HTTP, Telnet, SNMP, and ICMP frames, because
they are used for configuration and management of the access
point. Additionally, you cannot filter broadcast ARP request packets
if the target IP address belongs to the local access point or to an
access point in the subtree rooted at the local access point.
3. In each Allow/Pass field, check or uncheck the boxes to Allow or Pass.
4. In each field, select the down arrow on the right side of the Scope field
and set the scope to Unlisted or All.