Allied Telesis AT-S97 - Manual (Page 99)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
99
SYSTEM SHOW CLUSTER
Syntax
system show cluster
Parameters
None.
Privilege Levels
Administrator, read-write and read-only.
Description
This command displays the model names and slot assignments of the
management and media converter modules in a chassis or stack, as well
as the chassis’ module name and MAC address. This command does not
display stacking, power supply, or fan modules.
This command is similar to the SYSTEM SHOW CHASSIS command in
that both commands display the same information about a chassis. Where
they differ is that the SYSTEM SHOW COMMAND can display only one
chassis at a time and requires a chassis ID number. In contrast, this
command displays all of the chassis of a stack and does not require an ID
number.
The SYSTEM SHOW CLUSTER command is typically used to view the
basic information above on a single chassis that is not part of a stack or for
all of the chassis of a stack. The SYSTEM SHOW CHASSIS command is
intended for situations where there is a stack and, rather than viewing all of
the devices, you want to focus on just one of the units.
Figure 12 on page 100 illustrates this command on a stack of three
chassis. For an explanation of the information, refer to “SYSTEM SHOW
CHASSIS” on page 96.