Allied Telesis AT-S97 - Manual (Page 147)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
147
The section accepts the following AT-S97 Management Software
commands:
ˆ “SYSTEM SET ASYNCHRONOUS” on page 58
ˆ “SYSTEM SET CONSOLE” on page 61
ˆ “SYSTEM SET CONTACT” on page 62
ˆ “SYSTEM SET HOSTNAME” on page 63
ˆ “SYSTEM SET LOCATION” on page 64
ˆ “SYSTEM SET MODULE” on page 86
The module’s name is set with a modified version of the SYSTEM SET
MODULE command, where the MODULE keyword is replaced with
MYMODULE and the management module slot is indicated in the ID
parameter with “0” (zero) rather than “M”. This modified command also
sets the temperature thresholds of the management module and the
power supply and fan modules. The command with the slot ID of “0” (zero)
sets the temperature threshold for the management module while the
commands with the slot IDs of “A” and “B” (for example, “0/A” and “0/B”)
set this parameter for the power supply and fan modules. For further
information on this command, refer to “SYSTEM SET MODULE” on
page 86.
IP Configuration
The commands in this section define the IP configuration of the
management module.
Figure 25. IP Configuration Section
This section accepts the following commands:
ˆ “IP DHCP DISABLE” on page 50
ˆ “IP DHCP ENABLE” on page 51
ˆ “IP SET” on page 52
### Ip Configuration
ip dhcp disable
ip set ip-address=192.168.1.2
ip set subnetmask=255.255.255.0
ip set default-gateway=0.0.0.0