Allied Telesis AT-S97 - Manual (Page 69)

69
Chapter 6
Port and Module Commands
This chapter describes the system commands that control the parameters
on the ports and channels on the media converter modules. This chapter
contains the following sections:
ˆ “Overview” on page 70
ˆ “SYSTEM RESET CHASSIS” on page 72
ˆ “SYSTEM RESET CLUSTER” on page 74
ˆ “SYSTEM RESET MODULE” on page 76
ˆ “SYSTEM SET INTERFACE” on page 79
ˆ “SYSTEM SET MODULE” on page 86
ˆ “SYSTEM SET PORT” on page 89
ˆ “SYSTEM SHOW CHASSIS” on page 96
ˆ “SYSTEM SHOW CLUSTER” on page 99
ˆ “SYSTEM SHOW INTERFACE” on page 101
ˆ “SYSTEM SHOW MODULE” on page 108
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
see “Saving Your Configuration Changes” on page 17 or Chapter 9,
“Configuration File Commands” on page 141.