Allied Telesis AT-S97 - Manual (Page 111)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
111
ˆ Module Type - The model name.
ˆ Power OK - A status of Yes signifies the input power is within the
module’s operating range. A status of No signals that the input power
is less or greater than the permitted range. This parameter only applies
to the power supply and fan modules.
ˆ Voltages - Operating voltages. These are output voltages for the
AT-MCF2000AC Power Supply Module and input voltages for all other
modules.
ˆ Temperature - The current temperature of the module. On the
AT-MCF2000AC Power Supply Module and the AT-MCF2KFAN Fan
Module, the temperature is measured at the point where the outside air
enters the chassis from the cooling vents. The temperature for all other
modules is measured on the circuit board.
ˆ Temperature Threshold - The temperature threshold of a module. The
management module logs an event in the event log if the threshold is
exceeded, to warn of possible excessive temperature in the wiring
closet or chassis. Refer to “SYSTEM SET MODULE” on page 86 for
instructions on setting a module’s temperature threshold.
ˆ Management Port - The status of the link of the 10/100/1000Base-T
Management port on the AT-MCF2000M Management Module and, if
the port has a link to a network device, the current settings. Refer to
“SYSTEM SET PORT” on page 89 for instructions on setting this port.
ˆ Stacking Port - The status of the Stack port connection on the
AT-MCF2000M Management Module. A status of Up indicates the port
has established a link with a Stack port in another chassis.
Examples
This command displays information about the AT-MCF2000M
Management Module in a chassis with an ID number of 0:
system show module id=0/m
This command displays information about the media converter module in
slot 2 in a chassis with an ID number of 0:
system show module id=0/2