Allied Telesis AT-S97 - Manual (Page 94)

Chapter 6: Port and Module Commands
94
Examples
This command disables Auto-Negotiation of the twisted pair port in
channel 5 of a media converter module and sets the port’s speed and
duplex mode to 100 Mbps, half-duplex. The module is in slot 2 of a chassis
with an ID number of 1. Call-outs in the example identify the parts of the ID
number:
This command enables twisted port 5. The module is in slot 1 of a chassis
with an ID number of 3:
system set port id=3/1/5/a port-state=enable
This command disables Auto-Negotiation of the twisted pair port in
channel 2 of a media converter module and sets the port’s speed and
duplex mode to 10 Mbps, full-duplex, and the MDI/MDI-X setting to MDI.
The module is in slot 1 of a chassis with an ID number of 1:
system set port id=1/1/2/a auto-neg=disable speed=10
duplex=full crossover=mdi
This command activates Auto-Negotiation on the twisted pair port in
channel 4. The module is in slot 1 of a chassis with an ID of 2:
system set port id=2/1/4/a auto-neg=enable
This command sets the duplex mode to half-duplex for the fiber optic port
in channel 11 on a module in slot 2 of a chassis with an ID of 2:
system set port id=2/2/11/b duplex=half
This command disables the fiber optic port in channel 6 of the module in
slot 1. The chassis has the ID number 3:
system set port id=3/1/6/b port-state=disable
The previous examples illustrate how to configure a single port on a media
converter module. By omitting the PORT PAIR parameter, you can
configure all of the ports of the same type (that is, twisted pair or fiber optic
ports) with just one command. This is illustrated in the following two
examples.
system set port id=0/2/5/a auto-neg=disable speed=100 duplex=half
Chassis
Slot Port Pair (Channel)
Port