Allied Telesis AT-S97 - Manual (Page 90)

Chapter 6: Port and Module Commands
90
port Specifies the letter of a port in a
channel on a media converter
module. Possible values are:
a Specifies a twisted pair port. If
you specify only a port and not
a channel, then all of the
twisted pair ports are specified.
b Specifies a fiber optic port. If
you specify only a port and not
a channel, then all of the fiber
ports are specified.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CLUSTER” on page 99 or “SYSTEM
SHOW CHASSIS” on page 96. To view the ports of a
channel, refer to “SYSTEM SHOW INTERFACE” on
page 101.
port-state Enables and disables the port. Available settings are:
enable Activates the transmitter and receiver on the
port. This is the default setting.
disable Deactivates the transmitter and receiver on the
port.
auto-neg Activates and deactivates IEEE 802.3u Auto-Negotiation
and auto-MDI/MDIX on a port. When Auto-Negotiation is
activated, the port’s speed, duplex mode, and wiring
configuration are set automatically. Available settings are:
enable Activates IEEE 802.3u Auto-Negotiation and
auto-MDI/MDIX on the port. This is the default
setting for a twisted pair port. This is also the
default setting for fiber optic ports that support
Auto-Negotiation, such as 100Base-SX ports.
This setting is not appropriate for fiber optic
ports that do not support Auto-Negotiation, such
as 100Base-FX and 1000Base-F.
disable Deactivates IEEE 802.3u Auto-Negotiation and
auto-MDI/MDIX on the port.
speed Sets the speed of a twisted pair port. Available settings are:
10 Sets the speed of the port to 10 Mbps.
100 Sets the speed of the port to 100 Mbps.