Allied Telesis AT-S97 - Manual (Page 107)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
107
ˆ Port State - The state of the port:
Enabled - The port is enabled.
Disabled - The port was disabled with SYSTEM SET PORT command.
For information, refer to “SYSTEM SET PORT” on page 89.
ˆ Link Status - The status of the link of a port to its network device. For
definitions, refer to Table 4, “Port Status in the Link Test Mode” on page
104, Table 5, “Port Status in the Missing Link Mode” on page 104, or
Table 6, “Port Status in the Smart Missing Link Mode” on page 104.
ˆ Auto Negotiation - A status of Enabled is an indication that the twisted
pair port’s speed, duplex mode, and MDI/MDI-X wiring configuration
are set automatically with Auto-Negotiation and the auto-MDI/MDI-X
feature. A status of Disabled means the port’s speed, duplex mode,
and MDI/MDI-X wiring configuration were set manually.
ˆ Speed - The speed of the port when the parameter is set manually.
This parameter does not reflect the actual current speed when a port is
using Auto-Negotiation.
ˆ Duplex - The duplex mode of the port when the parameter is set
manually. This parameter does not reflect the actual current duplex
mode when a port is using Auto-Negotiation.
ˆ MDI Crossover - The wiring configuration of the twisted pair port.
ˆ Ingress and Egress Rate Limits - The settings for the packet filtering
feature. For information, refer to “SYSTEM SET PORT” on page 89.
To configure the channels and ports of a media converter module, refer to
“SYSTEM SET INTERFACE” on page 79 and “SYSTEM SET PORT” on
page 89.
Examples
This command displays a list of the media converter modules in a chassis
with an ID number of 0:
system show interface id=0
This command displays the status of all the channel ports on a media
converter module in slot 2 of a chassis with an ID number of 1:
system show interface id=1/2
This command displays the parameter settings for the two ports of channel
11 of a media converter module in slot 1 of a chassis with ID number of 1:
system show interface id=1/1/11