Allied Telesis AT-S97 - Manual (Page 86)

Chapter 6: Port and Module Commands
86
SYSTEM SET MODULE
Syntax
system set module id= chassis / slot name= name
temperature-threshold= value
Parameters
id Specifies a module in the chassis. The command can
configure only one module at a time. The ID consists of the
following parts:
chassis Identifies the ID number of the chassis. The
chassis ID number depends on which module is
installed in the management slot of the chassis.
When a management module is installed in this
slot, the chassis ID number is 0 or 31. When a
stacking module is installed in this slot, the
chassis ID can be from 1 to 30.
slot Specifies the number or letter of the chassis slot
with the module. Possible values are:
m Identifies the management module
slot. Either the management module
or the stacking module can be
installed in this slot.
1 or 2 Specifies a slot number of a media
converter module. In the
AT-MCF2000 Chassis, the left slot is
1 and the right slot is 2 when the unit
is viewed from the front.
a or b Specifies a slot letter of a power
supply or fan module. In the
AT-MCF2000 Chassis, the left slot is
A and the right slot is B when the unit
is viewed from the back.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CLUSTER” on page 99 or “SYSTEM
SHOW CHASSIS” on page 96.
name Assigns a name of up to 20 alphanumeric characters to the
module. Spaces are permitted, but a name with spaces
must be enclosed in double quotes (“ “). To remove the
current value without specifying a new value, enter “none”.
To view the current name of a module, refer to “SYSTEM