Allied Telesis AT-S97 - Manual (Page 168)

Chapter 10: File System Commands
168
ˆ The 10/100/1000Base-T Management port on the AT-MCF2000M
Management Module must be connected to the network. The
management module communicates with the TFTP server through this
port.
ˆ The AT-MCF2000M Management Module must have an IP
configuration. For instructions, refer to Chapter 4, “IP Configuration
Commands” on page 47.
ˆ The TFTP server must be a member of the same network as the
management module or have access to it through Layer 3 routing
devices.
ˆ If the management module and TFTP server are on different networks,
the IP configuration on the management module must include a
default gateway specifying the IP address of the first hop to reaching
the server. For instructions, refer to Chapter 4, “IP Configuration
Commands” on page 47.
Guidelines to Using the Xmodem Client
The following guidelines apply to the Xmodem client on the management
module when downloading a file to the management module with the FILE
DOWNLOAD command:
ˆ Your network must have a node with Xmodem server software.
ˆ To download a file, you must store the file on the Xmodem server.
ˆ Start the Xmodem server software before performing the download
command.
ˆ You must connect the 10/100/1000Base-T Management port on the
AT-MCF2000M Management Module to the network. The
management module communicates with the Xmodem server through
this port.
ˆ The AT-MCF2000M Management Module must have an IP
configuration. For instructions, refer to Chapter 4, “IP Configuration
Commands” on page 47.
ˆ The Xmodem server must be a member of the same network as the
management module or have access to it through Layer 3 routing
devices.
Command
Summary
Table 13 summarizes the file system commands.
Table 13. File System Commands
Command Description
“FILE COPY” on page 170 Creates copies of the
configuration files in the file
systems of the management and
media converter modules.