Allied Telesis AT-S97 - Manual (Page 74)

Chapter 6: Port and Module Commands
74
SYSTEM RESET CLUSTER
Syntax
system reset cluster
Parameters
None.
Privilege Level
Administrator.
Description
This command returns the parameter settings on the management and
media converter modules in a chassis or stack to the default values.
Note
This command deletes all of the master and auxiliary configuration
files in the file systems of the modules in the chassis, and so should
be used with caution. To retain any master configuration files on the
management module, you must upload them from the module to a
TFTP server before issuing this command. For instructions, refer to
“FILE UPLOAD” on page 191.
Note
The command involves a reset of the media converter modules in
the chassis or stack. Some network traffic may be discarded by the
modules.
Note
The management module is unresponsive to commands for
approximately one minute while it initializes the AT-S97
Management Software.
Note
The media converter modules in the chassis immediately resume
forwarding network traffic through their ports and channels using the
default settings. However, they are unresponsive to management
commands for approximately one minute while they initialize their
AT-S85 Management Software.