Allied Telesis AT-S97 - Manual (Page 158)

Chapter 9: Configuration File Commands
158
CONFIG SAVE FILESYSTEM
Syntax
config save filesystem=system:// chassis / slot / filename .cfg
Parameter
filesystem Specifies the location and name for the new master
configuration file. This parameter consists of the following
parts:
chassis Specifies the ID number of the chassis that
houses the management module where the
file will be stored. The ID number for the
chassis with a management module is either
0 or 31.
slot Identifies the slot with the module where the
new master configuration file is stored.
Since a master configuration file must be
stored in the file system on the management
module, the only supported value for the slot
is:
m Identifies the management
module slot and the
AT-MCF2000M Management
Module.
filename.cfg Specifies a name for the new master
configuration file. The name can be up to 15
alphanumeric characters, not including the
extension. Spaces are allowed, but a name
with spaces must be enclosed in double
quotes. The filename must include the
“.CFG” extension. Configuration filenames
are case sensitive.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CHASSIS” on page 96 or “SYSTEM
SHOW CLUSTER” on page 99. To view the filenames of
the current configuration files in a file system on a module,
refer to “FILE SHOW” on page 188.
Privilege Levels
Administrator and read-write.