Allied Telesis AT-S97 - Manual (Page 68)

Chapter 5: General System Commands
68
SYSTEM SHOW INFO
Syntax
system show info
Parameters
None.
Privilege Levels
Administrator, read-write, and read-only.
Description
This command displays the stack’s name, the name of the network
administrator responsible for managing the units, and the location of the
stack, as shown in Figure 10.
Figure 10. SYSTEM SHOW INFO Command
To configure these parameters, see the following commands:
ˆ “SYSTEM SET HOSTNAME” on page 63
ˆ “SYSTEM SET CONTACT” on page 62
ˆ “SYSTEM SET LOCATION” on page 64.
Example
system show info
System Information
Hostname ............ Engineering MCF
Contact ............. Jane Smith
Location ............ Bldg 3, Fl 1, Closet 122