Allied Telesis AT-S97 - Manual (Page 205)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
205
SNMP SET
Syntax
snmp set mgrip1= ipaddress mgrip2= ipaddress mgrip3= ipaddress
mgrip4= ipaddress Get-community= string Set-community= string
Trap-community= string
Parameters
mgrip1 - mrip4 Indicates the SNMP manager IP address for SNMP
manager 1 through SNMP manager 4. Specifies up
to four IP addresses of network management
stations that will receive SNMP traps from the unit.
The default value is 000.000.000.000. This is an
optional parameter. Enter a value in the following
format: xxx.xxx.xxx.xxx
Get-community Indicates the get community string. The unit
responds to get requests from a network manager
only when the get community strings of the agent
and network manager match. Enter a value between
1 and 14 characters. Community strings are case
sensitive and contain spaces and special characters
such as an exclamation (!) point. The default value
is “public.”
Set-community Indicates the set community string. The unit sends
traps to another unit. Enter a value between 1 and
14 characters. Community strings are case
sensitive and contain spaces and special characters
such as an exclamation (!) point. The default value
is “private.”
Trap-community Indicates the trap community string. Indicates the
SNMP manager receives SNMP traps from the unit.
Enter a value between 1 and 14 characters.
Community strings are case sensitive and contain
spaces and special characters such as an
exclamation (!) point. The default value is “public.”
Privilege Levels
Administrator and read-write
Description
This command sets the network manager IP addresses and community
information.