Allied Telesis AT-S97 - Manual (Page 162)

Chapter 9: Configuration File Commands
162
CONFIG SHOW
Syntax
config show
Parameters
None
Privilege Levels
Administrator, read-write, and read-only.
Description
This command displays the names of the current and active master
configuration files on the management module. An example is shown in
Figure 34.
Figure 34. CONFIG SHOW Command
The “Last configuration file ran” field displays the name of the master
configuration file used by the management module to configure the
chassis during the last reset or power cycle.
The “Current set configuration file” field displays the name of the active
master configuration file. It is this file that the management module
updates when the CONFIG SAVE command is issued. This is also the file
that is used to configure the chassis during the next reset or power cycle.
Here is an example of how the process works. Assume the chassis is
currently using a master configuration file called “unit12.cfg,” as illustrated
in Figure 34.
Now assume you decide to configure the settings on the chassis modules
using a different master file called “mcf24.cfg.” If, after specifying the file
as the new active configuration file with the CONFIG SET command, you
issue the CONFIG SHOW command, the information in Figure 35 on page
163 is displayed.
Last configuration file ran ............. unit12.cfg
Current set configuration file .......... unit12.cfg (Exists)
Active master configuration file