Allied Telesis AT-S97 - Manual (Page 192)

Chapter 10: File System Commands
192
dstfile=tftp Specifies the TFTP server to receive the file. This
parameter uploads a configuration file from a management
or media converter module to a TFTP server. This
parameter has the following parts:
ipaddress Specifies the IP address of the TFTP server.
filename.cfg Specifies a name for the file when uploaded
to the FTP server. Enclose the filename in
double quotes if it contains a space. The
filename extension must be “.CFG.”
dstfile=system
Specifies the module to receive the file when transferring a
configuration file between modules in a chassis. This
parameter has the following parts:
chassis Specifies the ID number of the chassis with
the file. The value of the ID number is 0
or 31.
slot Identifies the slot with the management
module to receive the file. The only accepted
value for this parameter is:
m Identifies the management slot
with the AT-MCF2000M
Management Module.
Privilege Levels
Administrator and read-write.
Description of Syntax 1
This command uploads a configuration file from a management module or
media converter module to an TFTP server. Typically, this command is
used to upload a master configuration file from a management module
before editing it at your workstation or transferring it to another
management module in another chassis.
Although this command can also be used to upload a media converter’s
auxiliary configuration file from the file system of a management module or
media converter module, Allied Telesis recommends against this. Editing
or transferring an auxiliary configuration file serves no purpose since the
settings are overwritten by the master configuration file on the
management module after the file is installed on a media converter
module. For further information on configuration files, refer to “Overview”
on page 142.