Allied Telesis AT-S97 - Manual (Page 160)

Chapter 9: Configuration File Commands
160
CONFIG SET
Syntax
config set filesystem=system:// chassis / slot / filename .cfg
Parameter
filesystem Specifies the location and name of a master configuration
file. This parameter consists of the following parts:
chassis Specifies the ID number of the chassis with
the management module where the file is
stored. The ID number for a chassis with a
management module is 0 or 31.
slot Identifies the slot with the module and the
master configuration file. Since a master
configuration file is stored on the
management module, the only supported
value is:
m Identifies the management
module slot and the
AT-MCF2000M Management
Module.
filename.cfg Specifies the name of a active master
configuration file. The filename must include
the “.CFG” extension and is case sensitive.
To view the filenames of the configuration
files in a file system on a management
module, refer to “FILE SHOW” on page 188.
If the filename has spaces, enclose it in
double quotes (“ “).
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CHASSIS” on page 96 or “SYSTEM
SHOW CLUSTER” on page 99.
Privilege Levels
Administrator and read-write.
Description
This command designates the active master configuration file on the
management module. For an explanation of the master configuration file,
refer to “Overview” on page 142.