Allied Telesis AT-S97 - Manual (Page 170)

Chapter 10: File System Commands
170
FILE COPY
Syntax
file copy srcfile=system:// chassis / slot / filename .cfg
dstfile=system:// chassis / slot / filename .cfg
Parameter
srcfile=system
Specifies the location and name of the master configuration
file to copy. This parameter consists of the following parts:
chassis Specifies the ID number of the chassis with
the file. The value of the ID number is either
0 or 31.
slot Identifies the slot with the module containing
the file. Possible values are:
m Identifies the management
module slot and the
AT-MCF2000M Management
Module.
1 or 2 Specifies a slot number of a
media converter module. In the
AT-MCF2000 Chassis, the left
slot is 1 and the right slot is 2.
filename.cfg Specifies the name of the master
configuration file to copy. Enclose the
filename in double quotes if it contains a
space. The filename must include the
“.CFG” extension. The name is case
sensitive.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CHASSIS” on page 96 or “SYSTEM
SHOW CLUSTER” on page 99. To view the filenames in a
file system on a module, refer to “FILE SHOW” on
page 188.
dstfile=system
Specifies the name of the new copy of the master
configuration file. The destination must have the same
chassis and slot location as the source. The name can be
up to 15 alphanumeric characters, not including the
extension. Spaces are allowed, but a name with spaces