Allied Telesis AT-S97 - Manual (Page 128)

Chapter 8: Event Log and Syslog Client Commands
128
LOGGING ENABLE SYSLOG
Syntax
logging enable syslog
Parameters
None.
Privilege Levels
Administrator and read-write
Description
This command activates the syslog client on the management module.
The module immediately begins to send the event messages generated
by the modules in the chassis to the syslog server. The default setting for
the syslog client is disabled. The IP address of the syslog server is
specified with “LOGGING SET EVENTLOG” on page 129. To display the
current status of the syslog client, refer to “LOGGING SHOW” on
page 132.
Note
For the requirements of the syslog client, refer to “Syslog Client
Guidelines” on page 122,
Example
The following command enables the syslog client:
logging enable syslog