Allied Telesis AT-S97 - Manual (Page 55)

55
Chapter 5
General System Commands
This chapter describes the commands that control and display basic
parameters on the management module. This chapter contains the
following sections:
ˆ “Overview” on page 56
ˆ “SYSTEM SET ASYNCHRONOUS” on page 58
ˆ “SYSTEM SET CHASSIS” on page 59
ˆ “SYSTEM SET CLOCK” on page 60
ˆ “SYSTEM SET CONSOLE” on page 61
ˆ “SYSTEM SET CONTACT” on page 62
ˆ “SYSTEM SET HOSTNAME” on page 63
ˆ “SYSTEM SET LOCATION” on page 64
ˆ “SYSTEM SHOW ASYNCHRONOUS” on page 65
ˆ “SYSTEM SHOW CLOCK” on page 66
ˆ “SYSTEM SHOW CONSOLE” on page 67
ˆ “SYSTEM SHOW INFO” on page 68
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
refer to “Saving Your Configuration Changes” on page 17 or Chapter
9, “Configuration File Commands” on page 141.