Allied Telesis AT-S97 - Manual (Page 91)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
91
1000 Sets the speed of the port to 1000 Mbps. This
setting is applicable to the 10/100/1000Base-T
port on the management module. This setting is
not supported on the twisted pair and fiber optic
ports on the AT-MCF2012LC and
AT-MCF2012LC/1 Media Converter Modules.
duplex Sets the duplex mode of a port. Available settings are:
full Sets the duplex mode of the port to full-duplex.
This is the default setting for a fiber optic port
that does not support Auto-Negotiation.
half Sets the duplex mode of the port to half-duplex.
crossover Sets the wiring configuration of a twisted pair port. Auto-
Negotiation must be disabled on the port to set this
parameter. Available settings are:
mdi Sets the wiring configuration to MDI.
mdix Sets the wiring configuration to MDI-X.
ingress-rate-limit
Defines the maximum number of bits per second a port
accepts from the network device connected to it.
egress-rate-limit
Defines the maximum number of bits per second a port will
transmit to the network device connected to it.
Privilege Levels
Administrator and read-write.
Description
This command configures the following parameter settings on a port in a
media converter channel:
ˆ Port status
ˆ Auto-Negotiation
ˆ Speed and duplex mode
ˆ MDI/MDI-X wiring configuration
ˆ Ingress and egress filtering