Allied Telesis AT-S97 - Manual (Page 76)

Chapter 6: Port and Module Commands
76
SYSTEM RESET MODULE
Syntax
system reset module id= chassis / slot
Parameters
id Identifies the media converter module or management
module to reset. The ID number consists of the following
parts:
chassis Identifies the ID number of the chassis. The
chassis ID number depends on which module is
installed in the management slot of the chassis.
When a management module is installed in this
slot, the chassis ID number is 0 or 31. When a
stacking module is installed in this slot, the
chassis ID can be from 1 to 30.
slot Specifies the letter or ID number of the slot with
the module. Possible values are:
m Identifies the management module
slot which contains either the
AT-MCF2000M Management
Module or the AT-MCF2000S
Stacking Module.
1 or 2 Specifies a slot number of a media
converter module. In the
AT-MCF2000 Chassis, the left slot is
1 and the right slot is 2.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CHASSIS” on page 96 or “SYSTEM
SHOW CLUSTER” on page 99.
Privilege Levels
Administrator and read-write.
Description
This command performs a soft reset on a module in a chassis by
initializing the AT-S85 or AT-S97 Management Software. You might reset
a module if it is experiencing a problem.